Policy based routing Amprnet

Setup een amprnet gateway met policy based routing.

Neem een kijkje op deze website voor de uitleg.
http://wiki.ampr.org/wiki/Startampr

############# tunnel ampr.org ################################
ifconfig tunl0 up 44.137.31.65/27 multicast
ip tunnel change ttl 64 mode ipip tunl0
ip link set dev tunl0 up
################# default route naar gw-44-137.ampr.org ##################
ip route add default dev tunl0 via 213.222.29.194 onlink table 44
######################## route ampr.org #################################
ip rule add to 44.0.0.0/8 table 44 priority 44
ip rule add from 44.137.31.64/27 table 44 priority 45
# Xnet Route
ip route add 44.137.31.70 dev sl0 table 44 src 44.137.31.69
# Jnos Route
ip route add 44.137.31.67 dev tun0 table 44 src 44.137.31.68
ip rule add from 44.137.31.64/27 to 192.168.1.0/24 table main priority 22
ip rule add to 44.137.31.64/27 table main priority 44
ip rule add dev tunl0 table 44 priority 45
ip rule add dev eth0 table 44 priority 46
ip rule add from 44.137.31.64/27 table 44 priority 47

### STARTS THE ampr-ripd ROUTER DAMEON
# -s saves routes to /var/lib/ampr-ripd/encap.txt
# -r use raw socket instead of multicast
# -t routing table to use
# -i tunnel interface to use
# -p RIPv2 password (latest ampr-ripd defaults to the current valid password)
# -a ampr subnets to be ignored (remove your allocation from the table)
/usr/sbin/ampr-ripd -s -r -t 44 -i tunl0 -L [email protected]

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.